Users Guide

Basic Installation of the DRAC 5 35
4 Configure the network controller LAN parameters to use DHCP or a
Static IP address source.
a Using the down-arrow key, select LAN Parameters , and press <Enter>.
b Using the up-arrow and down-arrow keys, select IP Address Source .
c Using the right-arrow and left-arrow keys, select DHCP or Static .
d If you selected Static , configure the Ethernet IP Address , Subnet
Mask
, and Default Gateway settings.
e Press <Esc>.
5 Press <Esc>.
6 Select Save Changes and Exit .
The system automatically reboots.
NOTE: When viewing the Web user interface on a Dell PowerEdge™ 1900 system
that is configured with one NIC, the NIC Configuration page displays two NICs
(NIC1 and NIC2). This behavior is normal. The PowerEdge 1900 system (and other
Dell systems that are configured with a single LAN On Motherboard) can be
configured with NIC teaming. Shared and Teamed modes work independently on
these systems.
See the Dell OpenManage Baseboard Management Controller Utilities User’s
Guide for more information about the Dell Remote Access Configuration Utility.
Software Installation and Configuration Overview
This section provides a high-level overview of the DRAC 5 software
installation and configuration process. Configure your DRAC 5 using the
Web-based interface, RACADM CLI, or Serial/Telnet/SSH console.
For more information about the DRAC 5 software components, see
"Installing the Software on the Managed System".
Installing Your DRAC 5 Software
To install your DRAC 5 software:
1
Install the software on the managed system. See "Installing the Software
on the Managed System".
2 Install the software on the management station. See "Installing the
Software on the Management Station".