Users Guide

254 Configuring Intelligent Platform Management Interface (IPMI)
c In the Network Configuration page under IPMI LAN Settings , select
Enable IPMI Over LAN and click Apply Changes .
d Update the IPMI LAN channel privileges, if required.
NOTE: This setting determines the IPMI commands that can be executed
from the IPMI over LAN interface. For more information, see the IPMI 2.0
specifications.
Under IPMI LAN Settings , click the Channel Privilege Level Limit
drop-down menu, select
Administrator , Operator , or User and click
Apply Changes .
e Set the IPMI LAN channel encryption key, if required.
NOTE: The DRAC 5 IPMI supports the RMCP+ protocol.
Under IPMI LAN Settings in the Encryption Key field , type the
encryption key and click
Apply Changes .
NOTE: The encryption key must consist of an even number of hexadecimal
characters with a maximum of 40 characters.
3 Configure IPMI Serial over LAN (SOL).
a In the System tree, click Remote Access .
b In the Configuration tab, click Serial Over LAN .
c In the Serial Over LAN Configuration page, select Enable Serial
Over LAN
.
d Update the IPMI SOL baud rate.
NOTE: To redirect the serial console over LAN, ensure that the SOL baud rate
is identical to your managed system’s baud rate.
e
Click the Baud Rate drop-down menu, select the appropriate baud
rate, and click
Apply Changes .
f Update the Minimum Required Privilege . This property defines the
minimum user privilege that is required to use the
Serial Over LAN
feature.
Click the
Channel Privilege Level Limit drop-down menu, select
User , Operator , or Administrator .
g Click Apply Changes .