Users Guide

Installing and Setting Up the DRAC 5 59
4 Under Platform Events Filters Configuration , select the Enable Platform
Event Filter alerts
check box and then click Apply Changes .
5 Under Platform Event Filters List , double-click a filter that you wish to
configure.
6 In the Set Platform Events page, make the appropriate selections and then
click
Apply Changes .
NOTE: Generate Alert must be enabled for an alert to be sent to any valid,
configured destination (PET or e-mail).
Configuring PEF Using the RACADM CLI
1 Enable PEF.
Open a command prompt, type the following command, and press <Enter>:
racadm config -g cfgIpmiPef -o cfgIpmiPefEnable -i
1 1
where 1 and 1 are the PEF index and the enable/disable selection, respectively.
The PEF index can be a value from 1 through 17. The enable/disable
selection can be set to 1 (Enabled) or 0 (Disabled).
For example, to enable PEF with index 5, type the following command:
racadm config -g cfgIpmiPef -o cfgIpmiPefEnable -i
5 1
2
Configure your PEF actions.
At the command prompt, type the following command and press <Enter>:
racadm config -g cfgIpmiPef -o cfgIpmiPefAction -i
1 <action>
where the <action> values bits are as follows:
•
<action> value bit 0 – 1 = enable alert action, 0 = disable alert
•
<action> value bit 1 – 1 = power off; 0 = no power off
•
<action> value bit 2 – 1 = reboot; 0 = no reboot
•
<action> value bit 3 – 1 = power cycle; 0 = no power cycle