Users Guide

Installing and Setting Up the DRAC 5 53
If IPMI serial is in terminal mode, you can configure the following
additional settings:
• Delete control
• Echo control
• Line edit
• New line sequences
• Input new line sequences
For more information about these properties, see the IPMI 2.0
specification.
Configuring IPMI Using the RACADM CLI
1 Login to the remote system using any of the RACADM interfaces. See
"Using RACADM" on page 210.
2 Configure IPMI over LAN.
Open a command prompt, type the following command, and press
<Enter>:
racadm config -g cfgIpmiLan -o cfgIpmiLanEnable 1
NOTE: This setting determines the IPMI commands that can be executed from the
IPMI over LAN interface. For more information, see the IPMI 2.0 specifications.
a
Update the IPMI channel privileges.
At the command prompt, type the following command and press
<Enter>:
racadm config -g cfgIpmiLan -o
cfgIpmiLanPrivilegeLimit
<level>
where <level> is one of the following:
•
2 (User)
•
3 (Operator)
•
4 (Administrator)