Users Guide

RACADM Subcommand Overview 265
getniccfg
NOTE: To use the getniccfg command, you must have Log In To DRAC 5 permission.
Table A-21 describes the setniccfg and getniccfg subcommands.
Synopsis
racadm getniccfg
Description
The getniccfg subcommand displays the current Ethernet management port
settings.
Sample Output
The getniccfg subcommand will display an appropriate error message if the
operation is not successful. Otherwise, on success, the output displayed in the
following format:
NIC Enabled = 1
DHCP Enabled = 1
IP Address = 192.168.0.1
Subnet Mask = 255.255.255.0
Gateway = 192.168.0.1
Supported Interfaces
•Local RACADM
• Remote RACADM
• telnet/ssh/serial RACADM
Table A-21. setniccfg/getniccfg
Subcommand Definition
getniccfg Displays the current IP configuration for the controller.