Users Guide

RACADM Subcommand Overview 263
ping
NOTE: To use this command, you must have Execute Diagnostic Commands or
Configure DRAC 5 permission.
Table A-19 describes the ping subcommand.
Synopsis
racadm ping <ipaddress>
Supported Interfaces
• Remote RACADM
• telnet/ssh/serial RACADM
setniccfg
NOTE: To use the setniccfg command, you must have Configure DRAC 5
permission.
Table A-20 describes the setniccfg subcommand.
NOTE: The terms NIC and Ethernet management port may be used
interchangeably.
Table A-19. ping
Subcommand Definition
ping Verifies that the destination IP address is reachable from the
DRAC 5 with the current routing-table contents. A destination
IP address is required. An ICMP echo packet is sent to the
destination IP address based on the current routing-table
contents.
Table A-20. setniccfg
Subcommand Definition
setniccfg Sets the IP configuration for the controller.