Users Guide

220 Using the RACADM Command Line Interface
Modifying the DRAC 5 IP Address
When you modify the DRAC 5 IP address in the configuration file, remove all
unnecessary <variable>=value entries. Only the actual variable group’s label
with "[" and "]" remains, including the two <variable>=value entries
pertaining to the IP address change.
For example:
#
# Object Group "cfgLanNetworking"
#
[cfgLanNetworking]
cfgNicIpAddress=10.35.10.110
cfgNicGateway=10.35.10.1
This file will be updated as follows:
#
# Object Group "cfgLanNetworking"
#
[cfgLanNetworking]
cfgNicIpAddress=10.35.9.143
# comment, the rest of this line is ignored
cfgNicGateway=10.35.9.1
The command racadm config -f myfile.cfg parses the file and identifies any
errors by line number. A correct file will update the proper entries.
Additionally, you can use the same getconfig command from the previous
example to confirm the update.
Use this file to download company-wide changes or to configure new systems
over the network.
NOTE: "Anchor" is an internal term and should not be used in the file.