Users Guide

Using the RACADM Command Line Interface 217
The .cfg file is first parsed to verify that valid group and object names are
present and that some simple syntax rules are being followed. Errors are
flagged with the line number that detected the error, and a simple message
explains the problem. The entire file is parsed for correctness, and all errors
are displayed. Write commands are not transmitted to the DRAC 5 if an error
is found in the .cfg file. The user must correct all errors before any
configuration can take place. The
-c option may be used in the config
subcommand, which verifies syntax only and does not perform writes to the
DRAC 5.
Use the following guidelines when you create a .cfg file:
• If the parser encounters an indexed group, it is the value of the anchored
object that differentiates the various indexes.
The parser reads in all of the indexes from the DRAC 5 for that group. Any
objects within that group are simple modifications when the DRAC 5 is
configured. If a modified object represents a new index, the index is
created on the DRAC 5 during configuration.
• The user cannot specify a desired index in a
.cfg file.
Indexes may be created and deleted, so over time the group may become
fragmented with used and unused indexes. If an index is present, it is
modified. If an index is not present, the first available index is used. This
method allows flexibility when adding indexed entries where the user does
not need to make exact index matches between all the RACs being
managed. New users are added to the first available index. A
.cfg file that
parses and runs correctly on one DRAC 5 may not run correctly on another
if all indexes are full and you must add a new user.
•Use the
racresetcfg subcommand to configure all DRAC 5 cards with
identical properties.
Use the
racresetcfg subcommand to reset the DRAC 5 to original defaults,
and then run the
racadm config -f <filename>.cfg
command. Ensure that the .cfg file includes all desired objects, users,
indexes, and other parameters.
NOTICE: Use the racresetcfg subcommand to reset the database and the DRAC 5
NIC settings to the original default settings and remove all users and user
configurations. While the root user is available, other users’ settings are also reset
to the default settings.