Users Guide

214 Using the RACADM Command Line Interface
fwupdate Executes or displays status on DRAC 5 firmware updates.
getssninfo Displays information about active sessions.
getsysinfo Displays general DRAC 5 and system information.
getractime Displays the DRAC 5 time.
ifconfig Displays the current RAC IP configuration.
netstat Displays the routing table and the current connections.
ping Verifies that the destination IP address is reachable from the
DRAC 5 with the current routing-table contents.
setniccfg Sets the IP configuration for the controller.
getniccfg Displays the current IP configuration for the controller.
getsvctag Displays service tags.
racdump Dumps DRAC 5 status and state information for debug.
racreset Resets the DRAC 5.
racresetcfg Resets the DRAC 5 to the default configuration.
serveraction Performs power management operations on the managed system.
getraclog Displays the RAC log.
clrsel Clears the System Event Log entries.
gettracelog Displays the DRAC 5 trace log. If used with -i, the command
displays the number of entries in the DRAC 5 trace log.
sslcsrgen Generates and downloads the SSL CSR.
sslcertupload Uploads a CA certificate or server certificate to the DRAC 5.
sslcertdownload Downloads a CA certificate.
sslcertview Views a CA certificate or server certificate in the DRAC 5.
testemail Forces the DRAC 5 to send an e-mail over the DRAC 5 NIC.
testtrap Forces the DRAC 5 to send an SNMP over the DRAC 5 NIC.
vmdisconnect Forces a virtual media connection to close.
vmkey Resets the virtual flash size to its default size (16 MB).
Table 9-2. RACADM Subcommands
(continued)
Command Description