Users Guide

Installing and Setting Up the DRAC 5 43
2 Enable PET.
At the command prompt, type the following commands and press <Enter> after each command:
racadm config -g cfgIpmiPet -o cfgIpmiPetAlertEnable -i 1 1
where 1 and 1 are the PET destination index and the enable/disable selection, respectively.
The PET destination index can be a value from 1 through 4. The enable/disable selection can be set to
1 (Enabled) or 0 (Disabled).
For example, to enable PET with index 4, type the following command:
racadm config -g cfgIpmiPet -o cfgIpmiPetAlertEnable -i 4 0
3
Configure your PET policy.
At the command prompt, type the following command and press <Enter>:
racadm config -g cfgIpmiPet -o cfgIpmiPetAlertDestIPAddr -i 1
<IP_address>
where 1 is the PET destination index and <IP_address> is the destination IP address of the system
that receives the platform event alerts.
4 Configure the Community Name string.
At the command prompt, type:
racadm config -g cfgIpmiLan -o cfgIpmiPetCommunityName <Name>
Configuring E-Mail Alerts
Configuring E-mail Alerts Using the Web User Interface
1 Login to the remote system using a supported Web browser. See "Accessing the Web-Based Interface."
2 Ensure that you followed the procedures in "Configuring PEF Using the Web User Interface."
3 Configure your e-mail alert settings.
a In the Alert Management tab, click Email Alert Settings .
b Under SMTP (Email) Server Address settings , configure the SMTP (Email) Server IP address
field with the appropriate information and then click Apply Changes .
4 Configure your e-mail alert destination.
a In the Email Alert Number column, click an e-mail alert number.
b Ensure that the Enable Email Alert checkbox is selected.
c In the Destination Email Address field, type a valid e-mail address.
d In the Email Description field, enter a description (if required).
e Click Apply Changes .