Users Guide

36 Installing and Setting Up the DRAC 4
Configuring the DRAC 4 Network Settings Using the Option ROM
The DRAC 4 contains an integrated NIC with a default IP address of
192.168.0.120 and a default gateway of 192.168.0.1. To use the DRAC 4 IDE
Option ROM utility to configure these settings and a limited number of
additional DRAC 4 network settings, perform the following steps:
1
Access the DRAC 4 IDE Option ROM utility during the managed system’s
boot process.
Within 5 seconds after the DRAC 4 banner, firmware version, and current
NIC IP address appear, press <Ctrl><d>.
The
Setup screen appears. Below the screen title is the Network Interface
Properties
menu.
2 Select and change the DRAC 4 NIC properties (see Table 2-1). The Virtual
Media settings are on page two.
Use the following guidelines when changing the DRAC 4 NIC properties:
• Use the <
Page Up > and < Page Down > keys to move between
the two pages.
• All menu selections are not case sensitive.
• Type one-key stroke selections.
NOTE: When modifying any of the following options, press <Esc> while typing
the value to avoid modifying the current value. If you press <Option Edit> and
it toggles a setting (changes the setting between only two possible values),
press <Option Edit> again to change the value back to the original setting.
Pressing <Esc> will not undo a modification after you type a new value.
Toggle options are not affected when you press <Esc>.