Users Guide

206 racadm Subcommand Man Pages
ping
NOTE: To use this command, you must have Execute Diagnostic Commands or
Configure DRAC 4 permission.
Table A-20 describes the ping subcommand.
Synopsis
racadm ping < ipaddress >
setniccfg/getniccfg
NOTE: To use the setniccfg command, you must have Configure DRAC 4
permission.
NOTE: To use the getniccfg command, you must have Log In To DRAC 4 permission.
Table A-21 describes the setniccfg and getniccfg subcommands.
NOTE: The terms NIC and Ethernet management port may be used
interchangeably.
Table A-20. ping
Subcommand Definition
ping Verifies that the destination IP address is reachable
from the DRAC 4 with the current routing-table
contents. A destination IP address is required.
An ICMP echo packet is sent to the destination
IP address based on the current routing-table
contents.
Table A-21. setniccfg/getniccfg
Subcommand Definition
setniccfg Sets the IP configuration for the controller.
getniccfg Displays the current IP configuration for the
controller.