Users Guide

182 Using the Serial and racadm Commands
racadm config -g cfgLanNetworking -o
cfgDNSServersFromDHCP 0
racadm config -g cfgLanNetworking -o cfgDNSServer1
192.168.0.5
racadm config -g cfgLanNetworking -o cfgDNSServer2
192.168.0.6
racadm config -g cfgLanNetworking -o
cfgDNSRegisterRac 1
racadm config -g cfgLanNetworking -o cfgDNSRacName
RAC-EK00002
racadm config -g cfgLanNetworking -o
cfgDNSDomainNameFromDHCP 0
racadm config -g cfgLanNetworking -o cfgDNSDomainName
MYDOMAIN
NOTE: If cfgNicEnable is set to 0, the DRAC 4 LAN is disabled even if DHCP is
enabled.
Frequently Asked Questions
Table 8-6 lists frequently asked questions and answers.
Table 8-6. Using the serial and racadm Commands: Frequently Asked
Questions
Question Answer
After performing a DRAC 4 reset
(using the racadm racreset
command), I issue a command
and the following message is
displayed:
racadm <command
name> Transport:
ERROR: (RC=-1)
What does this message mean?
You must wait until the DRAC 4 completes the
reset before issuing another command.