Users Guide

Managing and Recovering a Remote System 99
Table 4-31. DRAC 4 Log Messages
Message ID Description Suggested Action
RAC186W DHCP: no response from
server, need LAN address. The
NIC cannot be enabled until a
response is received from the
DHCP server.
Provides information only. No
specific corrective action is
indicated. Ensure that the DHCP
server is operational.
RAC188W DHCP: no response from
server, warm starting with <IP
address>.
Provides information only. No
specific corrective action is
indicated. Ensure that the DHCP
server is operational.
RAC189A Email page successful. Provides information only. No
corrective action is necessary.
RAC191E SNMP: internal failure during
trap generation
Reset the DRAC 4 and retry the
operation.
RAC198A SNMP: trap sent to <IP
address>
Provides information only. No
corrective action is necessary.
RAC199W Email paging attempts failed,
SMTP protocol failure
A trace of the SMTP connection may
be found in the trace log. Examine
the trace log to identify the source of
the protocol failure, such as the
connection could not be established
(SMTP server is down or an invalid
IP address), an invalid email
destination address, an invalid
domain in the email address, or the
SMTP server does not support
forwarding email. Correct the
problem and try again.
RAC256A
RAC257W
RAC258E
DRAC 4 hardware log event:
<formatted hardware log
event>
Provides information only. No
corrective action is necessary, unless
the contents of the hardware log
indicate a problem. In this case, the
corrective action is based on the
problem reported.
RAC016A DRAC 4 log cleared Provides information only.