Users Guide

Managing and Recovering a Remote System 77
Adding and Configuring SNMP Alerts
NOTE: You must have Configure DRAC 4 permission to add or delete an SNMP
alert; otherwise, these options will not be available.
1 Click the Configuration tab and select Alerts .
2 In the Add/Configure SNMP Alerts page, add, delete, configure, and test
the SNMP alerts.
NOTE: The DRAC 4 supports three severity levels: Informational, Warning, and
Severe. Some events support only the informational severity level because they
deliver only a message.
Adding an Alert
1 Locate an available Destination IP Address in the Destination IP Address
column.
NOTE: If all Destination IP Addresses are filled with existing IP addresses,
you have configured all of your existing alerts and must delete one to continue.
2 Click [Available] to open the Add/Configure SNMP Alerts page.
3 Use Table 4-7 to configure the following properties under General .
Table 4-7. Alert Properties
Property Description
Enable SNMP
Alert
Enables the current SNMP alert.
Community Specifies or edits the community name to which the destination
IP address belongs.
IP Address Specifies or edits the destination IP address to which the alert is
sent.
Apply Changes Commits changes made to the current alert.
Go Back To SNMP
Alerts Page
Returns you to the Configure SNMP Alerts page.