Users Guide

racadm Subcommand Man Pages 209
Description
The racdump subcommand provides a single command to get dump, status,
and general DRAC 4 board information.
The following commands are executed as a result of the single racdump
subcommand:
•getsysinfo
•coredump
• memmap
•netstat
• getssninfo
Output
The output of the individual commands are displayed.
racreset
NOTE: To use this command, you must have Configure DRAC 4 permission.
Table A-24 describes the racreset subcommand.
NOTICE: You must wait until the DRAC 4reset is completed before issuing
another command. If the DRAC 4 reset is not completed, you may receive the
following error:
racadm <command name> Transport: ERROR:
(RC=-1)
Synopsis
racadm racreset [hard | soft | graceful] [delay in
seconds]
Table A-24. racreset
Subcommand Definition
racreset Resets the DRAC 4.