Users Guide

racadm Subcommand Man Pages 189

config/getconfig

NOTE: To use the getconfig command, you must have Log In DRAC 4 permission.

Table A-4 describes the config and getconfig subcommands.

Synopsis

racadm config [-s -p -c] -f <filename>

racadm config [-s] -g <groupName> -o <objectName> [-i

racadm getconfig [-p] -f <filename>

racadm getconfig -g <groupName> [-i <index>]

racadm getconfig -u <username>

racadm getconfig -h

config Subcommand Description

The config subcommand allows the user to set DRAC 4 configuration

parameters individually or to batch them as part of a configuration file. After

the .cfg file has been correctly parsed, each object is read. If the content is the

same, a write to the DRAC 4 does not occur. If the data is different, that

DRAC 4 object is written with the new value.

Input

Table A-5 describes the config subcommand options.

NOTE: The -f, -s, and -p options are not supported for the serial/telnet console.

Table A-4. config/getconfig

Subcommand Definition

config Configures the DRAC 4.

getconfig Gets the DRAC 4 configuration data.