Users Guide

Using the Serial and racadm Commands 181
Adding a DRAC 4 User With Permissions
To add a user with specific administrative permissions (role-based authority),
first locate an available user index by performing the steps in "Before Adding a
DRAC 4 User." Next, type the following command lines with the new user
name and password.
NOTE: See Table B-1 for a list of the Bit Mask numbers to enable specific user
permissions. The default user permission is 0, which provides full admininstrative
permission.
racadm config -g cfgUserAdmin -o
cfgUserAdminPrivilege -i <index> <username> <Bit Mask
Number for specific user permissions>
Configuring DRAC 4 Network Properties
Type the following command to get a list of the available network properties:
racadm getconfig -g cfgLanNetworking
If you want to use DHCP to obtain an IP address, you can use the command
to write the object cfgNicUseDhcp to enable it. You may also type a static
IP address, netmask, and gateway.
The commands provide the same configuration functionality as the option
ROM does at boot-up time when you are prompted to type <Ctrl><d>. For
more information about configuring network properties with the option
ROM, see "Configuring DRAC 4 Network Properties."
The following is an example of how the command may be used to configure
desired LAN network properties.
racadm config -g cfgLanNetworking -o cfgNicEnable 1
racadm config -g cfgLanNetworking -o cfgNicIpAddress
192.168.0.120
racadm config -g cfgLanNetworking -o cfgNicNetmask
255.255.255.0
racadm config -g cfgLanNetworking -o cfgNicGateway
192.168.0.120
racadm config -g cfgLanNetworking -o cfgNicUseDhcp 0