Users Guide

18 DRAC 4 Overview
Connectors
NOTE: The DRAC 4 hardware installation instructions are located in the Installing a
Remote Access Card document or the Installation and Troubleshooting Guide
included with your system. Ensure that you connect the management cable and the
local video monitor (if present) to the DRAC 4/P in PCI slot 4.
The DRAC 4 provides a dedicated 10/100 Mbps RJ-45 NIC and a connector
for mounting the card to the system board. The DRAC 4/P also provides a
video connector, and a 30-pin Management Connector.
DRAC 4 Ports
Table 1-2 identifies the ports used by the DRAC 4. This information is
required when opening firewalls for remote access to a DRAC 4.
Table 1-2. DRAC 4 Port Numbers
DRAC 4 Port Number Used For
Ports on DRAC 4 listening for connection (server):
22 Secure Shell (configurable)
23 Telnet (configurable)
80 HTTP (configurable)
161 SNMP Agent (not configurable)
443 HTTPS (configurable)
3668 Virtual Media server (configurable)
5869 Remote racadm spcmp server (not configurable)
5900 Console Redirection (configurable)
Ports that DRAC 4 uses as a client:
25 SMTP (not configurable)
53 DNS (not configurable)
68 DHCP-assigned IP address
69 TFTP (not configurable)
162 SNMP trap (not configurable)
636 LDAP (not configurable)
3269 LDAP for global catalog (GC) (not configurable)