White Papers
Table Of Contents
- 1 Installing and configuring the DR Series system
- 2 Creating a disk-based target device on CA ARCserve
- 3 Creating a new backup job with the DR Series system as the target
- 4 Setting up DR native replication and restore from replication target
- 5 Setting up the DR Series system cleaner
- 6 Monitoring deduplication, compression, and performance
- A Creating a storage device for NFS
7 Setting Up the Dell™ DR Series System as a Backup Target on CA Arcserve | April 2015
7. Log on to the DR Series system administrator console with the IP address you just provided for the
DR Series system and with the username: administrator and password: St0r@ge! (The “0” in the
password is the numeral zero.).
8. Join the DR Series system to Active Directory by completing the following steps.
Note: if you do not want to add the DR Series system to Active Directory, please see the
DR Series
System
Owner’s Manual
for guest logon instructions.
a. Select Active Directory from the left navigation area.