White Papers
Table Of Contents
- 1 Installing and configuring the DR Series system
- 2 Creating a disk-based target device on CA ARCserve
- 3 Creating a new backup job with the DR Series system as the target
- 4 Setting up DR native replication and restore from replication target
- 5 Setting up the DR Series system cleaner
- 6 Monitoring deduplication, compression, and performance
- A Creating a storage device for NFS
4 Setting Up the Dell™ DR Series System as a Backup Target on CA Arcserve | April 2015
Executive summary
This paper provides information about how to set up the Dell DR Series system as a backup target for CA
ARCserve R16.
For additional information, see the DR Series system documentation and other data management
application best practices whitepapers for your specific DR Series system at:
http://www.dell.com/powervaultmanuals
Note: The DR Series system/CA ARCserve build version and screenshots used for this paper may vary
slightly, depending on the version of the DR Series system/ CA ARCserve software version used.