Administrator Guide

REMARQUE : Dell recommends using the Network Time Protocol (NTP) servers when the DR Series system is part

of a workgroup and not part of a domain. The NTP time mode is disabled when the DR Series system is joined to an

Active Directory Services (ADS) domain. Any attempt to enable the NTP time mode when you are joined to an ADS

domain displays an error message indicating this is not possible.

Understanding the System Configuration Page Options

The System Configuration page contains three key system options:

• Password Management

• Shutdown

• Reboot

Edit Password

Edit Password—click this option to display the Edit Password dialog, where you can change the login password for the

DR Series system

REMARQUE : To change CIFS login credentials, you can use the DR Series system CLI command, authenticate –set

–user . For details, see the

Dell DR Series System Command Line Reference Guide

REMARQUE : Editing your existing login password is different than resetting your login password. Click Edit

Password in the System Configuration page to edit your login password to reflect any value that meets the system

password requirements (for more information, see

Modifying the System Password. Click Reset Password in the

for your system. For more information, see Resetting the Default System Password.

Shutdown

Shutdown—click this option to display the Shutdown System dialog, where you can shut down the DR Series system.

PRÉCAUTION : Shutdown powers Off the appliance on which the system software is installed. Once in a powered

Off state, you can power it On at its physical location or using an iDRAC configuration to the system.

Reboot

Reboot—click this option to display the Reboot System dialog, where you can reboot the DR Series system.

Page et options de support

Cliquez sur Dashboard → Support (Tableau de bord → Support) dans la page Support. La page Support affiche les

informations en cours de support du système dans le volet Support Information (Informations de support) :

REMARQUE : Le nombre exact de listes Ethernet (MAC et Débit) affiché dépend du nombre et du type des ports

Ethernet installés dans le système. Par exemple, le système DR4000 peut prendre en charge jusqu'à quatre ports

1–GbE ou deux ports 10–GbE, alors que le système DR4100 peut prendre en charge jusqu'à six ports 1–GbE (quatre

ports 1–GbE internes sur la carte fille réseau et deux ports 1–GbE sur la carte d'extension PCI Express) ou deux

ports 10–GbE. L'exemple suivant montre quatre ports (de eth0 à eth3).

• Product Name

• Version du logiciel

• Numéro de service

• Dernière exécution de diagnostics

• BIOS Version