Administrator Guide

Alert Message Description/Meaning or Action
NVRAM does not match the data volume. If this is a newly replaced NVRAM, use the
maintenance --
hardware --reinit_nvram command to reinitialize the
NVRAM.
For more information, see the Dell DR Series System
Command Line Reference Guide .
Storage usage is approaching the system capacity. Clean up the filesystem. If issue persists, contact Dell
Support for possible assistance or intervention.
Replication re-sync cannot proceed. Namespace limit has reached its maximum.
Out of space on replication target. Clean up the filesystem. If issue persists, contact Dell
Support for possible assistance or intervention.
The filesystem has reached the maximum allowable limit
for files and directories. Creating new files and
directories will be denied.
Clean up the filesystem. If issue persists, contact Dell
Support for possible assistance or intervention.
Appliance available storage level reached VTL threshold,
unload all drives, expire old backups and schedule
filesystem cleaner. Run "vtl --set_rw ..." to set the
containers IO mode back to Read-Write.
Unload all the drives and ensure no carts are loaded. Clean
up the filesystem. To use the library again, set the VTL
containers to read-write mode using the CLI command “vtl
–set_rw”, after the filesystem comes back to read-write
mode.
System Chassis Alerts
Power Supply <
number > detected a failure.
• Reconnect the power cable to the designated power
supply unit if it is disconnected.
• Ensure that there is input AC power at the power
cable.
• Use a different power cord.
If this does not resolve the issue, replace the designated
power supply.
Power Supply <
number > is missing or has been removed.
• The power supply might not be making a proper
connection.
• Try reseating the power supply in the power supply
slot.
• Reconnect the power cable to the designated power
supply unit if it is disconnected.
• Ensure that there is input AC at the power cable.
• Use a different power cord.
If this does not resolve the issue, replace the designated
power supply.
Power Supply <
number > is unplugged.
• Reconnect the power cable to the designated power
supply unit if it is disconnected.
• Ensure that there is input AC power at the power
cable.
• Use a different power cord.
151