White Papers

DR Series Best Practice Guide
39
Troubleshooting
Follow the steps bellow to troubleshoot connectivity problems between source and target DRs.
a) Issue the following command to the target command to troubleshoot connectivity:
replication -- troubleshoot --peer <ip_address>
b) Make sure the management interface is up and reachable by using the following command:
telnet<manamgent_ip>
Cleaner
The DR appliance cleaner is process that is configured to run efficiently and effectively out of the box
with no tuning or adjusting required. Only in extreme cases will the DR cleaner possibly may need
calibration. This document is intended only for DR appliances which are exposed to the following
extreme cases:
 Ingesting or deleting 100TB’s or more per week
 Ingest occurs 24x7
 When poor savings is experienced or reported
 Full cleaner pass not finishing once per week
The DR Cleaner best practices guide can be found here.
Example
administrator@DR1 > replication --troubleshoot --peer 10.250.243.222
Testing connection to port 9904... Connected!
Testing connection to port 9911... Connected!
Testing connection to port 9915... Connected!
Testing connection to port 9916... Connected!
Replication troubleshooting completed successfully - Connection to all ports is OK!