Reference Guide

Replication relationship is not established with the target core
Description This issue occurs when the replication of protected agent is configured during the DL Appliance
Configuration Wizard, because sometimes protection of the machine is not completed when the replication
request is sent. This results in an empty replication being created. Thus when the replication request is
verified on the target core you do not see any agents.
Workaround/
Solution
Add the protected machines using the Replication tab.
Repository information is displayed incorrectly when protecting a
machine
Description This issue occurs when you try to store protected machine’s data in the repository (which is created during
the DL Appliance Configuration Wizard) using the Protect Machine wizard.
Workaround/
Solution
It is recommended to proceed with the Appliance setup. The repository status doesn’t impact the overall
configuration of the Appliance and Protection settings.
Repository creation fails with an error when you try to create a
repository less than 7 GB
Description
It is not recommended to provision small volumes for repositories. A repository should be at least 250 GB in
size.
Internet Explorer top bar is not displayed properly after running the DL
Appliance Configuration Wizard
Description
This issue occurs when you run the DL Appliance Configuration Wizard in the Recovery Mode. The buttons
Close, Restore, Minimize are not visible.
Workaround/
Solution
Close the Internet Explorer window and launch Rapid Recovery Core from the shortcut on the desktop.
Download Last link is displayed on the Download DL Appliance Log
pane even if logs were never collected
Workaround/
Solution
Before clicking the Download Last link, press Collect Logs and wait till the Log Collection Job finishes.
Virtual Network Adapters and Switches page does not update after
adding a new network adapter to ESXi VM
Description
After you add a new network adapter to the ESXi VM, the adapter name does not appear on the Virtual
Network Adapters and Switches page.
Workaround/
Solution
Close the wizard and open it again to see the added adapter. You can also verify through the vSphere Client
GUI.
7