CLI Reference Guide

DHCPv6 Snooping Commands 991
Syntax
show ipv6 source binding [{dhcp-snooping | static}] [interface interface-id ]
[vlan vlan-id]
• dhcp-snooping — Displays the DHCP snooping bindings.
• static —Displays the statically configured bindings.
Default Configuration
This command has no default configuration.
Command Modes
User EXEC, Privileged EXEC (all show modes)
User Guidelines
This command has no user guidelines.
Example
(console) #show ipv6 source binding
MAC Address IP Address Type Vlan Interface
----------------- --------------- ------------- ----- ---------
00:00:00:00:00:08 2000::1 dhcpv6-snooping 2 Gi1/0/1
00:00:00:00:00:09 3000::1 dhcpv6-snooping 3 Gi1/0/1
00:00:00:00:00:0A 4000::1 dhcpv6-snooping 4 Gi1/0/1
show ipv6 verify
Use the show ipv6 verify command to display the IPv6 Source Guard
configuration on all interfaces or the specified interface.
Syntax
show ipv6 verify [interface if-id ]
• if-id —A valid interface ID (physical)
Default Configuration
There is no default configuration for this command.
2CSNXXX_SWUM200.book Page 991 Tuesday, December 10, 2013 1:22 PM