CLI Reference Guide

DHCPv6 Commands 961
no domain-name domain
• domain — DHCPv6 domain name. (Range: 1–255 characters)
Default Configuration
This command has no default configuration.
Command Mode
IPv6 DHCP Pool Configuration mode
User Guidelines
DHCPv6 pool can have multiple number of domain names with maximum of
8.
Example
The following example sets the DNS domain name "test", which is provided
to a DHCPv6 client by the DHCPv6 server.
console(config)#ipv6 dhcp pool addrpool
console(config-dhcp6s-pool)#domain-name test
console(config-dhcp6s-pool)#no domain-name test
ipv6 dhcp pool
This capability requires the IPv6 DHCP service to be enabled. Use the service
dhcpv6 command to enable the DHCPv6 service. Use the ipv6 dhcp pool
command in Global Configuration mode to enter IPv6 DHCP Pool
Configuration mode. DHCPv6 pools are used to specify information for
DHCPv6 server to distribute to DHCPv6 clients. These pools are shared
between multiple interfaces over which DHCPv6 server capabilities are
configured.
Syntax
ipv6 dhcp pool pool-name
no ipv6 dhcp pool pool-name
• pool-name — DHCPv6 pool name. (Range: 1-31 characters)
2CSNXXX_SWUM200.book Page 961 Tuesday, December 10, 2013 1:22 PM