CLI Reference Guide

940 DHCP Server and Relay Agent Commands
domain-name (IP DHCP Pool Config)
Use the domain-name command in IP DHCP Pool Configuration mode to
set the DNS domain name which is provided to a DHCP client by the DHCP
server. The DNS name is an alphanumeric string up to 255 characters in
length. Use the no form of the command to remove the domain name.
Syntax
domain-name domain
no domain-name domain
• domain — DHCP domain name. (Range: 1–255 characters)
Default Configuration
This command has no default configuration.
Command Mode
IP DHCP Pool Configuration mode
hardware-address
Use the hardware-address command in DHCP Pool Configuration mode to
specify the MAC address of a client to be manually assigned an address. Use
the no form of the command to remove the MAC address assignment.
Syntax
hardware-address hardware-address
no hardware-address
• hardware-address —MAC address of the client. Either the
XXXX.XXXX.XXXX or XX:XX:XX:XX:XX:XX form of MAC address may
be used where XX is a hexadecimal digit.
Default Configuration
There are no default MAC address manual bindings.
2CSNXXX_SWUM200.book Page 940 Tuesday, December 10, 2013 1:22 PM