CLI Reference Guide

Data Center Bridging Commands 907
Traffic class group 7 is reserved by the system and is not shown.
Auto-configuration ports utilize the traffic class group mappings received
from the auto-configuration source. Manually configured ports enabled for
DCBX transmit the traffic class groups in the ETS TLVs.
Example
The following example demonstrates how to display the global traffic class to
group mappings:
s1# show classofservice traffic-class-group
Traffic Class Traffic Class Group
------------- ---------------------
0 0
1 1
2 1
3 1
4 2
5 1
6 1
show interfaces traffic-class-group
Use the show interfaces traffic-class-group command in Privileged EXEC
mode to display the Traffic Class to Traffic Class Group mapping.
Syntax
show interfaces traffic-class-group [ interface-id ]
• interface-id —A valid physical interface specifier.
Default Configuration
The default is to show the global traffic class group configuration.
Command Mode
Privileged EXEC mode
User Guidelines
NOTE: This command is only available on N40xx series switches.
2CSNXXX_SWUM200.book Page 907 Tuesday, December 10, 2013 1:22 PM