CLI Reference Guide

Data Center Bridging Commands 895
User Guidelines
NOTE: This command is only available on N40xx series switches.
This command has no user guidelines.
Examples
console# show lldp tlv-select interface te1/0/1
Interface ETS Config ETS Recommend PFC App Priority QCN
------------ ---------- ------------- --- ------------ ---
te1/0/1Yes No Yes No Yes
console# show lldp tlv-select interface all
Interface ETS Config ETS Recommend PFC App Priority QCN
----------- ---------- ------------- --- ------------ ---
te1/0/1Yes No Yes No Yes
te1/0/2No No Yes No Yes
show lldp dcbx
Use the show lldp dcbx command in Privileged EXEC mode to display the
Traffic Class to Traffic Class Group mapping.
Syntax
show lldp dcbx [interface <all|interface-id <detail|status>>]
• interface-id —A valid physical interface specifier.
•
all —All interfaces.
•
detail —Display detailed DCBX information.
•
status —Display a status summary.
Default Configuration
This command has no default setting.
Command Mode
Privileged EXEC
User Guidelines
NOTE: This command is only available on N40xx series switches.
2CSNXXX_SWUM200.book Page 895 Tuesday, December 10, 2013 1:22 PM