CLI Reference Guide

860 802.1x Commands
Use the no form of this command to return the port to the default order of
priority for the authentication methods.
Syntax
authentication priority [mab | dot1x | captive-portal] [mab | dot1x |
captive-portal] [mab | dot1x | captive-portal]
no authentication priority
Default Configuration
There is no default configuration for this command.
Command Modes
Interface VLAN Configuration mode.
User Guidelines
Each method can only be entered once. There are no restrictions on the
priority ordering of methods.
Example
console(config-if-Gi1/0/1)# authentication priority mab dot1x captive-portal
console(config-if-Gi1/0/1)# no authentication priority
authentication restart
Use this command to set the interval after which reauthentication starts. This
timer starts only if all the authentication methods fail.
Use the no form of this command to set the authentication restart timer to
factory default value.
Syntax
authentication restart time
no authentication restart
• time —The time, in seconds, after which reauthentication starts, if all the
authentication methods have failed. Range: 300-65535.
2CSNXXX_SWUM200.book Page 860 Tuesday, December 10, 2013 1:22 PM