CLI Reference Guide

852 802.1x Commands
Default Configuration
Periodic reauthentication is disabled.
Command Mode
Interface Configuration (Ethernet) mode
User Guidelines
This command has no user guidelines.
Example
The following example enables periodic reauthentication of the client.
console(config)# interface gigabitethernet 1/0/16
console(config-if-Gi1/0/16)# dot1x reauthentication
dot1x system-auth-control
Use the dot1x system-auth-control command in Global Configuration mode
to enable 802.1x globally. To disable 802.1x globally, use the no form of this
command.
Syntax
dot1x system-auth-control
no dot1x system-auth-control
Default Configuration
The default for this command is disabled.
Command Mode
Global Configuration mode
User Guidelines
This command enables local processing of IEEE 802.1x frames on the switch.
Dot1x eapolflood mode must be disabled for local processing to occur.
2CSNXXX_SWUM200.book Page 852 Tuesday, December 10, 2013 1:22 PM