CLI Reference Guide

VLAN Commands 827
Default Configuration
This command has no default configuration.
Command Mode
Global Configuration mode
User Guidelines
This command has no user guidelines.
Example
console(config)# vlan protocol group 1
vlan protocol group add protocol
Use the vlan protocol group add protocol command in Global Configuration
mode to add a protocol to the protocol-based VLAN groups identified by
groupid . A group may have more than one protocol associated with it. Each
interface and protocol combination can be associated with one group only. If
adding a protocol to a group causes any conflicts with interfaces currently
associated with the group, this command fails and the protocol is not added
to the group.
To remove the protocol from the protocol-based VLAN group identified by
groupid , use the no form of this command.
Syntax
vlan protocol group add protocol groupid ethertype value
no vlan protocol group add protocol groupid ethertype value
• groupid — The protocol-based VLAN group ID, which is automatically
generated when you create a protocol-based VLAN group with the
vlan
protocol group
command. To see the group ID associated with the name
of a protocol group, use the
show port protocol all command.
•
ethertype value — The protocol you want to add. The ethertype value can
be any valid hexadecimal number in the range 0x0600 to 0xffff.
2CSNXXX_SWUM200.book Page 827 Tuesday, December 10, 2013 1:22 PM