CLI Reference Guide

808 VLAN Commands
Example
The following example displays detailed information for port 1/0/1.
console#show dvlan-tunnel interface 1/0/1
Interface Mode EtherType
--------- ------- --------------
1/0/1 Enable vMAN
show interfaces switchport
Use the show interfaces switchport command in Privileged EXEC mode to
display switchport configuration, including the private VLAN mappings.
Syntax
show interfaces switchport {{gigabitethernet unit/slot/port | port-channel
port-channel-number | tengigabitethernet unit/slot/port|
fortygigabitethernet unit/slot/port}}
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode, Interface Configuration mode and all Configuration
submodes
User Guidelines
Do not configure private VLANs on ports configured with any of these
features:
• Link Aggregation Control Protocol (LACP)
• Multicast VLAN Registration (MVR)
EtherType This field represents a 2-byte hex EtherType to be used as the first
16 bits of the DVLAN tunnel. The three different EtherType tags
are: (1) 802.1Q, which represents the commonly used value of
0x8100. (2) vMAN, which represents the commonly used value of
0x88A8. (3) If EtherType is not one of these two values, it is a
custom tunnel value, representing any value in the range of 0 to
65535.
2CSNXXX_SWUM200.book Page 808 Tuesday, December 10, 2013 1:22 PM