CLI Reference Guide

778 TACACS+ Commands
Example
console(config)# tacacs-server key encrypted
f6fdffe48c908deb0f4c3bd36c032e72f6fdffe48c908deb0f4c3bd36c032e72f6fdffe48c90
8deb0f4c3bd36c032e72f6fdffe48c908deb0f4c3bd36c032e72f6fdffe48c908deb0f4c3bd3
6c032e72f6fdffe48c908deb0f4c3bd36c032e72f6fdffe48c908deb0f4c3bd36c032e72f6fd
ffe48c908deb0f4c3bd36c032e72
console(config)#
tacacs-server timeout
Use the tacacs-server timeout command in Global Configuration mode to set
the interval during which a switch waits for a server host to reply. To restore
the default, use the no form of this command.
Syntax
tacacs-server timeout [ timeout ]
no tacacs-server timeout
• timeout — The timeout value in seconds. (Range: 1–30)
Default Configuration
The default value is 5 seconds.
Command Mode
Global Configuration mode
User Guidelines
This command has no user guidelines.
Example
The following example sets the timeout value as 30.
console(config)#tacacs-server timeout 30
timeout
Use the timeout command in TACACS Configuration mode to specify the
timeout value in seconds. If no timeout value is specified, the global value is
used.
2CSNXXX_SWUM200.book Page 778 Tuesday, December 10, 2013 1:22 PM