CLI Reference Guide

704 RADIUS Commands
Command Mode
Radius (accounting) mode
User Guidelines
There are no user guidelines for this command.
Example
The following example sets port number 56 for accounting requests.
console(config)#radius-server host acct 3.2.3.2
console(Config-acct-radius)#acct-port 56
auth-port
Use the auth-port command in Radius mode to set the port number on which
the RADIUS server listens for authentication requests.
Syntax
auth-port auth-port-number
• auth-port-number — Port number for authentication requests. (Range: 1 -
65535)
Default Configuration
The default value of the port number is 1812.
Command Mode
Radius mode
User Guidelines
User must enter the mode corresponding to a specific Radius server before
executing this command.
Example
The following example sets the port number 2412 for authentication
requests.
console(config)#radius-server host 192.143.120.123
2CSNXXX_SWUM200.book Page 704 Tuesday, December 10, 2013 1:22 PM