CLI Reference Guide

674 QoS Commands
– set-prec-transmit ip-prec — Remark the IP precedence in the packet to
ip-prec and transmit. (Range 0-7)
–
set-dscp-transmit dscp-val — Remark the DSCP in the packet to dscp-
val
and transmit. (Range 0-63)
–
set-cos-transmit 802.1p-priority — Remark the 802.1p priority in the
packet to
802.1p-priority and transmit. (Range 0-7)
– transmit— Transmit the packet unmodified.
Default Configuration
This command has no default configuration.
Command Mode
Policy-Class-Map Configuration mode
User Guidelines
The CIR and PIR are measured in Kbps (not pps as indicated in the RFC),
the CBS in Kbytes, and the PBS in Kbytes. It is recommended that the CBS
and PBS be configured to be larger than the largest expected IP packet. A
class command in policy-map mode must be issued for an existing class-map
before entering this command.
Example
console#police-two-rate 100000000 64 1000000000 32 conform-action set-cos-
transmit 7 exceed-action set-prec-transmit 7 violate-action drop
policy-map
Use the policy-map command in Global Configuration mode to establish a
new DiffServ policy or to enter policy map configuration mode. To remove
the policy, use the no form of this command.
Syntax
policy-map policyname [in|out]
no policy-map
policyname
2CSNXXX_SWUM200.book Page 674 Tuesday, December 10, 2013 1:22 PM