CLI Reference Guide

640 QoS Commands
• classname — Specifies the name of an existing DiffServ class. (Range:
1–31 characters)
Default Configuration
This command has no default configuration.
Command Mode
Policy Map Configuration mode
User Guidelines
This command causes the specified policy to create a reference to the class
definition. The command mode is changed to Policy-Class-Map
Configuration when this command is executed successfully.
Example
The following example shows how to specify the DiffServ class name of
"DELL."
console(config)#policy-map DELL1
console(config-classmap)#class DELL
class-map
Use the class-map command in Global Configuration mode to define a new
DiffServ class of type
match-all . To delete the existing class, use the no form
of this command.
Syntax
class-map match-all class-map-name [{ipv4 | ipv6}]
no class-map match-all
class-map-name
• class-map-name — a case-sensitive alphanumeric string from 1 to 31
characters uniquely identifying an existing DiffServ class.
Default Configuration
The class-map defaults to ipv4.
2CSNXXX_SWUM200.book Page 640 Tuesday, December 10, 2013 1:22 PM