CLI Reference Guide

638 QoS Commands
process is also used for cases where a trusted port mapping is unable to be
honored, such as when a nonIP packet arrives at a port configured to trust the
IP precedence or IP DSCP value.
Commands in this Chapter
This chapter explains the following commands:
assign-queue mark ip-dscp match source-
address mac
show classofservice
dot1p-mapping
class mark ip-precedence match srcip show classofservice ip-
dscp-mapping
class-map match class-map match srcip6 show classofservice
trust
class-map rename match cos match srcl4port show diffserv
classofservice
dot1p-mapping
match destination-
address mac
match vlan show diffserv service
interface
classofservice ip-
dscp-mapping
match dstip mirror show diffserv service
interface port-channel
classofservice trust match dstip6 police-simple show diffserv service
brief
conform-color match dstl4port police-single-rate show interfaces cos-
queue
cos-queue min-
bandwidth
match ethertype police-two-rate show interfaces
random-detect
cos-queue random-
detect
match ip6flowlbl policy-map show policy-map
cos-queue strict match ip dscp random-detect
queue-parms
show policy-map
interface
diffserv match ip
precedence
random-detect
exponential-
weighting-constant
show service-policy
drop match ip tos redirect traffic-shape
mark cos match protocol service-policy vlan priority
2CSNXXX_SWUM200.book Page 638 Tuesday, December 10, 2013 1:22 PM