CLI Reference Guide

624 MLAG
Default Configuration
By default, no MLAG domains are configured.
Command Modes
Global Configuration mode
User Guidelines
Only one MLAG domain (domain 1) is supported.
Example
console(config)#vpc domain 1
console(config-vpc 1)#peer-keepalive enable
console(config-vpc 1)#peer-keepalive destination 192.168.0.2 source
192.168.0.1
console(config-vpc 1)#peer detection enable
console(config-vpc 1)#exit
vpc peer-link
Use the vpc peer-link command to configure a port channel as the MLAG
peer link for a domain and enables the peer link protocol.
Use the no form of the command to remove the peer link configuration from
an MLAG domain and disable the peer link protocol.
Syntax
vpc peer-link
no vpc peer-link
Default Configuration
There are no peer links configured by default.
Command Modes
Port-channel configuration mode
2CSNXXX_SWUM200.book Page 624 Tuesday, December 10, 2013 1:22 PM