CLI Reference Guide

MLAG 621
show vpc statistics
Use the show vpc statistics command to display the counters for the keepalive
messages trasmitted and received by the MLAG switch.
Syntax
show vpc statistics {peer-keepalive | peer-link}
Default Configuration
There is no default configuration for this command.
Command Modes
Privileged EXEC mode and above
User Guidelines
There are no user guidelines for this command.
Example
(console) # show vpc statistics peer-keepalive
Total trasmitted .......................................123
Tx successful...........................................118
Tx errors...............................................5
Total received..........................................115
Rx successful...........................................108
Rx Errors...............................................7
Timeout counter.........................................6
(console) # show vpc statistics peer-link
Peer link control messages transmitted..................123
Peer link control messages Tx errors................... 5
Peer link control messages Tx timeout.................. 4
Peer link control messages ACK transmitted............. 34
Peer link control messages ACK Tx erorrs............... 5
Peer link control messages received.................... 115
Peer link data messages trasmitted..................... 123
Peer link data messages Tx errors...................... 5
Peer link data messages Tx imeout...................... 4
Peer link data messages ACK transmitted................ 34
Peer link data messages ACK Tx erorrs.................. 5
Peer link data messages received....................... 115
Peer link BPDU’s tranmsitted to peer................... 123
2CSNXXX_SWUM200.book Page 621 Tuesday, December 10, 2013 1:22 PM