CLI Reference Guide

MLAG 619
show vpc consistency-features
Use the show vpc consistency parameters on both MLAG peers to display
MLAG related configuration information in a format suitable for comparison
with the other MLAG peer.
Syntax
show vpc consistency-features { global | interface port-channel-number }
• port-channel-number —A valid port-channel identifier (range 1-128).
Default Configuration
There is no default configuration for this command.
Command Modes
Privileged EXEC mode and above
User Guidelines
There are no user guidelines for this command.
show vpc peer-keepalive
Use the show vpc peer-keepalive command to display the peer MLAG
switch’s IP address used by the Dual Control Plane Detection Protocol. The
port used for the Dual Control Plane Detection Protocol is shown, as well as if
peer detection is enabled or not. If enabled, the detection status is displayed.
Syntax
show vpc peer-keepalive
Default Configuration
There is no default configuration for this command.
Command Modes
Privileged EXEC mode and above
2CSNXXX_SWUM200.book Page 619 Tuesday, December 10, 2013 1:22 PM