CLI Reference Guide

602 Port Channel Commands
Po2No Configured PortsStatic31
Hash Algorithm Type
1 - Source MAC, VLAN, Ethertype, source module and port ID
2 - Destination MAC, VLAN, Ethertype, source module and port ID
3 - Source IP and source TCP/UDP port
4 - Destination IP and destination TCP/UDP port
5 - Source/Destination MAC, VLAN, Ethertype, source MODID/port
6 - Source/Destination IP and source/destination TCP/UDP port
7 - Enhanced hashing mode
Example #2
console#show interfaces port-channel 1
Channel Ports Ch-Type Hash Type Min-links Local Prf
------- ----------------------------- -------- ---------- --------- --------
-
Po1 Inactive: Gi1/0/1, Gi1/0/2, Dynamic 3 1 Enabled
Gi1/0/3, Gi1/0/4
show lacp
Use this command in Privileged EXEC mode to display LACP information
for Ethernet ports.
Syntax
show lacp {gigabitethernet unit/slot/port| tengigabitethernet unit/slot/port |
fortygigabitethernet unit/slot/port [{parameters | statistics}]
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode, Configuration mode and all Configuration submodes
User Guidelines
This command has no user guidelines.
2CSNXXX_SWUM200.book Page 602 Tuesday, December 10, 2013 1:22 PM