CLI Reference Guide

556 LLDP Commands
no lldp med faststartrepeatcount
• count — Number of LLDPPDUs that are transmitted when the protocol is
enabled. (Range 1–10)
Command Mode
Global Configuration
Default Value
3
User Guidelines
No specific guidelines.
Example
console(config)# lldp med faststartrepeatcount 2
lldp med transmit-tlv
This command is used to specify which optional TLVs in the LLDP MED set
are transmitted in the LLDPDUs. There are certain conditions that have to
be met for this port to be MED compliant. These conditions are explained in
the normative section of the specification. For example, the MED TLV
'capabilities' is mandatory. By disabling this bit, MED is effectively disable on
this interface.
Syntax
lldp med transmit-tlv [capabilities] [network-policy] [ex-pse] [ex-pd]
[location] [inventory]
no med lldp transmit-tlv [capabilities] [network-policy] [ex-pse] [ex-pd]
[location] [inventory]
Command Mode
Interface (Ethernet) Configuration
Default Value
By default, the capabilities and network policy TLVs are included.
2CSNXXX_SWUM200.book Page 556 Tuesday, December 10, 2013 1:22 PM