CLI Reference Guide

426 Ethernet CFM Commands
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC, Configuration mode and all Configuration submodes
User Guidelines
This command has no user guidelines.
Example
show ethernet cfm maintenance-points local level 1
---- ----- ---- ---- ------ ----- -------- ------ ----------- -----
MPID Level Type VLAN Port Dire- CC MEP- Operational MAC
ction Transmit Active Status
---- ----- ---- ---- ------ ----- -------- ------ ----------- -----
1 1 MEP 10 1/0/1 UP Enabled True 00:02:bc:02:02:02
----- ---- ------ -----------------
Level Type Port MAC
----- ---- ------ -----------------
show ethernet cfm maintenance-points remote
Use the show ethernet cfm maintenance-points remote command in
Privileged EXEC mode to display the configured remote maintenance points.
Syntax
show ethernet cfm maintenance-points remote {level 0-7 | domain domain-
name
| detail [mac mac-address | mep MEPId ] [domain domain-name |
level
0-7 ] [vlan vlan-id ]}
• domain —Name of the maintenance domain (an alphanumeric string of
up to 43 characters in length).
•
level —Maintenance association level
•
mac-addr — The destination MAC address for which the connectivity needs to
be verified. Either MEP ID or the MAC address option can be used.
• vlan-id — A VLAN associated with the maintenance domain. Range: 1-4094.
• mpid — The MEP ID from which the loopback message needs to be
transmitted.
2CSNXXX_SWUM200.book Page 426 Tuesday, December 10, 2013 1:22 PM