CLI Reference Guide

404 Ethernet Configuration Commands
Syntax
shutdown
no shutdown
Default Configuration
The interface is enabled.
Command Mode
Interface Configuration (Ethernet, Port-Channel, Tunnel, Loopback) mode
User Guidelines
This command has no user guidelines.
Examples
The following example disables gigabit Ethernet port 1/0/5.
console(config)#interface gigabitethernet 1/0/5
console(config-if-Gi1/0/5)# shutdown
The following example reenables gigabit ethernet port 1/0/5.
console(config)#interface gigabitethernet 1/0/5
console(config-if-Gi1/0/5)# no shutdown
speed
Use the speed command in Interface Configuration mode to configure the
speed of a given Ethernet interface. To restore the default, use the no form of
this command.
Syntax
speed {10 | 100 | 1000 | 10000 | auto [10 | 100 | 1000 | 10000]}
no speed
• 10 —Configures the port to 10 Mbps operation.
•
100 —Configures the port to 100 Mbps operation.
•
1000 —Configures the port to 1000 Mbps operation.
•
10000 —Configures the port to 10 Gbps operation.
2CSNXXX_SWUM200.book Page 404 Tuesday, December 10, 2013 1:22 PM