CLI Reference Guide

394 Ethernet Configuration Commands
Syntax
show interfaces status
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode, Configuration mode and all Configuration submodes
User Guidelines
Port channels are only displayed if configured. Use the show interfaces port-
channel
command to display configured and unconfigured port channels.
Interfaces configured as stacking ports will show as detached in the output of
the
show interfaces status command.
The link state indicates the physical connectivity state of the link. It is
possible that the link is connected physically yet frames are not able to pass
over the link. Possible causes of this condition are speed or duplex mismatch.
The displayed port status information includes the following:
Example
The following example displays the status for all configured interfaces.
Field Description
Port The port or port channel number. Oob means Out-of-Band
Management Interface.
Description Description of the port.
Duplex Displays the port Duplex status.
VLAN The native VLAN for the port.
Speed Refers to the port speed.
Neg Describes the Auto-negotiation status.
Link State Displays the Link status, either Up or Down.
Flow Ctrl
Status
Displays the Flow Control status, either Active or Inactive.
2CSNXXX_SWUM200.book Page 394 Tuesday, December 10, 2013 1:22 PM