CLI Reference Guide

388 Ethernet Configuration Commands
Port Description Duplex Speed Neg MTU Admin
State
--------- ------------------------------ ------ ------- ---- ----- -----
Gi1/0/1 Full 1000 Auto 1518 Up
show interfaces counters
Use the show interfaces counters command in User EXEC mode to display
traffic seen by the interface.
Syntax
show interfaces counters [errors] [gigabitethernet unit/slot/port | port-
channel
port-channel-number | tengigabitethernet unit/slot/port |
fortygigabitethernet unit/slot/port]
• errors —Show the error counts (frame discards and reasons) in the in and
out direction.
•
gigabitethernet —Shows the traffic for the specified Gigabit Ethernet port.
•
port-channel —Shows the traffic for the specified port channel port.
•
tengigabitethernet —Shows the traffic for the specified 10-Gigabit
Ethernet port.
•
fortygigabitethernet —Shows the traffic for the specified 40-Gigabit
Ethernet port.
Default Configuration
This command has no default configuration.
Command Mode
User EXEC mode, Configuration mode and all Configuration submodes
User Guidelines
The following table describes the fields shown in the display:
Field Description
InOctets Counted received octets.
2CSNXXX_SWUM200.book Page 388 Tuesday, December 10, 2013 1:22 PM