CLI Reference Guide

372 Ethernet Configuration Commands
On a storm control enabled interface, if the ingress rate of that type of packet
(L2 broadcast, multicast, or unicast) is greater than the configured threshold
level (as a percentage of port speed or as an absolute packets-per-second rate),
the switch forwarding-plane discards the excess traffic.
The
speed command controls interface link speeds and auto-negotiation. If
speed is set to something other than auto, auto-negotiation is disabled on the
interface. Auto-negotiation will link at the highest possible speed supported
on the interface at full duplex.
Commands in this Chapter
This chapter explains the following commands:
clear counters
Use the clear counters command in Privileged EXEC mode to clear statistics
on an interface.
clear counters show interfaces counters speed
description show interfaces description storm-control broadcast
flowcontrol receive show interfaces detail storm-control multicast
interface show interfaces status storm-control unicast
interface range show interfaces transceiver switchport protected
monitor capture (Global
Configuration)
show monitor capture switchport protected name
monitor capture (Privileged
Exec)
show statistics show switchport protected
rate-limit cpu show statistics switchport show system internal
pktmgr
show interfaces advertise show storm-control show system mtu
show interfaces
configuration
shutdown system jumbo mtu
2CSNXXX_SWUM200.book Page 372 Tuesday, December 10, 2013 1:22 PM