CLI Reference Guide

358 E-mail Alerting Commands
Commands in this Chapter
This chapter explains the following commands:
logging email
Use the logging email command in Global Configuration mode to enable e-
mail alerting and set the lowest severity level for which log messages are e-
mailed. Use the no form of the command to disable e-mail alerting.
Syntax
logging email [ severity ]
no logging email
• severity —If you specify a severity level, log messages at or above the
severity level are e-mailed. The severity level may either be specified by
keyword or as an integer from 0 to 7. The accepted keywords, and the
numeric severity level each represents, are as follows.
–emergency (0)
–alert (1)
–critical (2)
– error (3)
– warning (4)
logging email show logging email statistics
logging email urgent clear logging email statistics
logging traps security
logging email message-type to-addr mail-server ip-address | hostname
logging email from-addr port (Mail Server Configuration Mode)
logging email message-type subject username (Mail Server Configuration
Mode)
logging email logtime password (Mail Server Configuration
Mode)
logging email test message-type show mail-server
2CSNXXX_SWUM200.book Page 358 Tuesday, December 10, 2013 1:22 PM